Toll Free Number :
1-866-455-COAT$ (2628)
1-866-455-COAT$ (2628)
After one thousand hours of continual use, UV degradation caused a “yellowing” finish on recessed lighting fixtures.
Linear Lighting fixtures comprised of steel and aluminum had inconsistent finishes caused by raw material variations and fabrication processes.
A high reflectance, low gloss coating which was easy to clean, yielding a minimal color shift after several thousand hours of continual use.
Textured and smooth coatings, available in easy clean, durable and high fashion colors, were applied at cost-effective rates.
Sorters, dividers, and bins had bare unpainted spots, caused by abrasion, after only a few months of use
A high abrasion resistant coating exhibiting exceptional toughness and lubricity was used which more than doubled previous product life expectancies.
Coatings on enclosures, cabinets and components suffered damage during assembly operations that resulted in slow production and increased need for rework.
Textured and smooth coatings with superior adhesion, impact resistance, and lubricity were used, which eliminated chipping and scratching problems during assembly while allowing for normal production rates.
Rods, tubes, posts and similar items could not be coated and cured within the Customer’s stringent time/temperature parameters. Powder had to be applied to a pre-heated part, then cured for a few seconds without additional heating, and fi nally quenched in cold water to conform to the desired line speed and space constraints
A unique, catalyzed coating that exceeded the process parameters, achieved full cure with 90% less energy, and allowed the Customer to achieve a 10% increase in productivity due to increased line speed. As an added benefit, AmeriCoats’ powder did not clog the Customer’s dual collector filters.